Required CCU firmware version: ≥ 3.0.0
sha256: 5f7fbb443dc73fb862b73cbac5d358133d484d7bafc956ad4d0e3d19330d1867
C H A N G E L O G
Please note: Only use the firmware file in connection with the current software-version of the CCUx!
Device: HmIP-E27 - HmIP-E27
Company: eQ-3, Maiburger Str. 29, 26789 Leer, Germany
Version 1.0.26 - 2026-02-20
** Improvement
- Error handling while WLAN setup
Version 1.0.24 - 2026-02-13
** Improvement
- Set USE_PARTNER_RAM_LOOKUP
Version 1.0.22 - 2026-02-10
** Bugfix
- ICMP Destination Unreachable isn't handled correctly
Version 1.0.20 - 2026-02-09
** Bugfix
- Device sometimes uses incorrect route
- Device repeatedly sends sequence number validations even though it has already been validated previously
Version 1.0.18 - 2026-02-06
** Improvement
- Use actual version of HmIPW-lib
- Use actual version of BBDC
Version 1.0.16 - 2026-02-04
** Improvement
- Use actual version of BBDC
Version 1.0.14 - 2026-02-04
** Improvement
- Don't handle frames addressed to Any* / handle only some All* frames
Version 1.0.12 - 2026-01-30
** Improvement
- Change gesture for factory reset
Version 1.0.10 - 2026-01-29
** Bugfix
- DEC UniversalLight - Hue&Sat: rapid color change during dimming
- PowerUP - HCL without function
- InclusionAccept is not send over router
Version 1.0.8 - 2026-01-23
** Bugfix
- Device sends sometimes TimeInformationRequest to the AllAC address at boot
** Improvement
- Optimize WLAN scan
- Optimize LED handling at boot
Version 1.0.6 - 2026-01-21
** Bugfix
- Retrigger Inclusion Request does not check SGTIN
- BT module does not switch off after 5 minutes
- After DEC-STOP, the color of the light bulb changes from TC to HSV mode.
** Improvement
- Adjust orange flashing slightly during power-up
- Add gamma correction
Version 1.0.4 - 2025-12-01
** Improvement
- Add RSSI to status frames
Version 1.0.2 - 2025-11-25
** Improvement
- BluFi: Disable setting WLAN data without security
Version 1.0.0 - 2025-11-17
** Bugfix
- Factory-Reset is done after 5th restart
- DEC with Hue and SAT is not handled, if HCL or Dim2Warm is active
- after restart frames repeatedly send
** Improvement
- Adjust dimming curve for TW
--- END OF FILE ---