sha256: 12642fc668d78953aefca827a98d03dd92084e79ba35ecb6f7bc5930ffb15dd7
C H A N G E L O G
Please note: Only use the firmware file in connection with the current software-version of the CCUx!
Device: HmIP-FROLL - Homematic IP Shutter Actuator for flush mount
Company: eQ-3, Maiburger Str. 29, 26789 Leer, Germany
Version 1.2.0 - 20170518
** Related Hardware
** Bugfix
- device doesn't send switching commands anymore if a link partner wasn't reachable before
Version 1.0.8 - 20170505
** Related Hardware
** Bugfix
- moving to position doesn't work if the parameter DRIVING_MODE is set to an extreme position and the shutter/blind has already this extreme position
Version 1.0.7 - 20170503
** Related Hardware
** Bugfix
- status info telegrams are partially longer than the maximum allowed length
Version 1.0.6 - 20170428
** Related Hardware
** Bugfix
- temperature isn't sent at boot
- RSSI is set in status error telegrams although this is no answer
Version 1.0.5 - 20170426
** Related Hardware
** Bugfix
- when the configuration button is pressed, the device hangs
Version 1.0.4 - 20170425
** Related Hardware
** Bugfix
- added missing sending of weekprogram status after inclusion
- status request doesn't work with weekprogram channel
Version 1.0.3 - 20170419
** Related Hardware
** Bugfix
- check if switch time is valid on current day was wrong, so switch times are always valid and are done every day.
- fixed bug on daylight saving time calculation
- HmIP-Schalt-/Dimm- und Rollladenaktoren senden ab dem ersten Auftreten einer Antwort mit NACK, nur noch Antworten mit NACK
- a switching command is now correctly answered with status info ack
- corrected wrong parameter index for LATITUDE in list 0
- answer with NACK if one triggered channel is inhibit
** Improvement
- added two testmode steps to be able to switch the normally opened and the changeover relay directly.
- added choice for the type of edge for testmode step SERVICE_ID_ZC_DELAY_PREPARE
- changed testmode zerocrossing measurement pin
- added inhibit functionality for incoming switch command
- added lock feature for weekprogram
Version 1.0.2 - 20170330
** Related Hardware
** Bugfix
- cyclic status info has no RSSI value of 0x80
- Actuator remains permanently on after configuration of the changeover time while the actuator is active
Version 1.0.0 - 20170321
** Related Hardware
** Comments
--- END OF FILE ---