sha256: 374c0999445e9ca15a9b74f645638922e04fded6a17b14a2718512e4ae06e7a8
Achtung! Bitte verwenden Sie die Firmware-Datei nur in Verbindung mit der CCU2(3) ab Version 2(3).29.23
Please note: Only use the firmware file in connection with the CCU2(3) from Version 2(3).29.23
** Bugfix * [HMIP_SMI-35]: A configuration of the PIR_OPERATION_MODE now influences the internal state for "motion_detection_on" * [HMIP_SMI-53]: Backup mechanism also triggered with NAK from SNC / StatusInfoReceiver.
** Modification * [HMIP_SMI-51]: New handling of event_counter in CndSwCmds implemented.
** New feature * [HMIP_SMI-49]: Implementation of HmIP Security Solution PRO functionalities.
** Bugfix * [HMIP_SMI-47]: A multicast telegram on the state reset channel (ch 2) caused a rx_stop forever and an increased current consumption.
** Bugfix *[HMIP_SMI-39]: Double ack after a received SwCmd generated an undefined frame that was sent out *[HMIP_SMI-41]: Non Ack_Status weren't sent with rssi code "unknown" *[HMIP_SMI-42]: Blink duty cycle signal once and send status if duty cycle limit is exceeded (status too when limit is undershot)
** Bugfix *[HMIP_SMI-35]: A configuration of the PIR_OPERATION_MODE now influences the internal state for "motion_detection_on" *[HMIP_SMI-36]: Only accept SwCmds from linkpartners on channel 2 for StateReset (not on channel 1) *[HMIP_SMI-37]: Discard a ConfigReqUpdate when ACK of a LinkPartner wasn't received, but let pass them when triggered by a keypress *[HMIP_SMI-38]: A status request causes a StatusAck which include a filtered and a current brightness. Other StatusAck's (i.e. after DirExStop) causes a StatusAck which includes only a filtered brightness.
** New feature *[HMIP_SMI-27]: Send two brightness values in a status_ack (1. Brightness = filtered, 2. Brightness = current) *[HMIP_SMI-28]: Reset motion state with blocking period when a switch command is received on the new channel 2 (input) *[HMIP_SMI-32]: Added parameter for disabling messages to the access controller
** HMOS Version 1.16.0
** Bugfix *[HMIP_SMI-30]: Send a status acknowledge after switch on or switch off the motion detection by a direct execution start (with level = 0 or level != 0)
** Modification
** New feature *[HMIP_SMI-27]: Send two brightness values in a status_ack (1. Brightness = filtered, 2. Brightness = current) *[HMIP_SMI-28]: Reset motion state with blocking period when a switch command is received on the new channel 2 (input) *[HMIP_SMI-32]: Added parameter for disabling messages to the access controller
** HMOS Version 1.16.0
** Comment
** Related Hardware
** Bugfix send filtered brightness value in the response to request status info
** Modification
** New feature
** HMOS Version 1.16.0
** Comment
** Related Hardware
** Bugfix
** Modification
** New feature Dirict execution stop to cancel motion activ timer
** HMOS Version 1.16.0
** Comment
** Related Hardware
** Bugfix
** Modification
** New feature
** HMOS Version 1.14.1
** Related Hardware
** HMOS Version 1.14.0
** Comment
** Related Hardware