sha256: 235f5b61fdd9200ba9076277cd74df6f637b404db5173e951d7598621c233e3e
Achtung! Bitte verwenden Sie die Firmware-Datei nur in Verbindung mit der CCU2(3) ab Version 2(3).29.23
Please note: Only use the firmware file in connection with the CCU2(3) from Version 2(3).29.23
** Bugfix *[HMIP_SMO-19]: A configuration of the PIR_OPERATION_MODE now influences the internal state for "motion_detection_on" *[HMIP_SMO-32]: Backup mechanism also triggered with NAK from SNC / StatusInfoReceiver. *[HMIP_SMO-33]: Backup mechanism also triggered when MAC_ACK failed.
** Modification * [HMIP_SMO-30]: New handling of event_counter in CndSwCmds implemented.
** New feature * [HMIP_SMO-48]: Implementation of HmIP Security Solution PRO functionalities.
** HMOS Version *
** Comment
** Related Hardware *
** Bugfix *[HMIP_SMO-26]: A multicast telegram on the state reset channel (ch 2) caused a rx_stop forever and an increased current consumption.
** Modification
** New feature *
** HMOS Version *
** Comment *
** Related Hardware *
** Bugfix *[HMIP_SMO-24]: Double ack after a received SwCmd generated an undefined frame that was sent out *[HMIP_SMO-25]: Non Ack_Status weren't sent with rssi code "unknown"
** Modification
** New feature *
** HMOS Version *
** Comment *
** Related Hardware *
** Bugfix
*[HMIP_SMO-19]: A configuration of the PIR_OPERATION_MODE now influences the internal state for "motion_detection_on"
*[HMIP_SMO-20]: Only accept SwCmds from linkpartners on channel 2 for StateReset (not on channel 1)
*[HMIP_SMO-21]: Discard a ConfigReqUpdate when ACK of a LinkPartner wasn't received, but let pass them when triggered by a keypress
*[HMIP_SMO-22]: A status request causes a StatusAck which include a filtered and a current brightness.
Other StatusAck's (i.e. after DirExStop) causes a StatusAck which includes only a filtered brightness.
** Modification
** New feature *
** HMOS Version *
** Comment *
** Related Hardware *
** Bugfix *[HMIP_SMO-16]: Send a status acknowledge after switch on or switch off the motion detection by a direct execution start (with level = 0 or level != 0) *[HMIP_SMO-12]: Motion state reset didn't work correctly when parameter "CaptureWithinInterval" was set. Bug fixed in timer routine.
** Modification
** New feature *[HMIP_SMO-11]: Send two brightness values in a status_ack (1. Brightness = filtered, 2. Brightness = current) *[HMIP_SMO-13]: Reset motion state with blocking period when a switch command is received on the new channel 2 (input) *[HMIP_SMO-18]: Added parameter for disabling messages to the access controller
** HMOS Version *
** Comment *
** Related Hardware
** Bugfix
** Modification
** New feature
** HMOS Version
** Comment
** Related Hardware