sha256: 72cf0f0277641e758a8340cc26bc75607769ce4fe23dbc33ff6f386c9d99629d
C H A N G E L O G
Please note: Only use the firmware file in connection with the current software-version of the CCUx!
Device: HmIPW-DRD3 - Homematic IP Wired Dimming Actuator - 3 channels
Company: eQ-3, Maiburger Str. 29, 26789 Leer, Germany
Version 1.4.8 - 2022-03-23
** Bugfix
- General improvements - Code optimisation
Version 1.4.6 - 2021-07-23
** Improvement
Version 1.4.4 - 2021-05-06
** Bugfix
- Dimming direction change if other input is press
- Wrong lock timeout handling for event counter
- Wrong order in the list 1 parameters of the real channel in dimmer actuators
- DEC ExecutionStart with level 0 is set channel to 100%
- Error if one or more channels are switching
- Error in the dst handling (changeover) if dst is given by SHC
Version 1.4.2 - 2021-03-11
** Improvement
- Adjustment behavior at "Channel inactive"
Version 1.4.0 - 2021-02-18
** Bugfix
- After a long button press, one channel will sporadically remain permanently supplied with 230 volts.
- A long keypress release leads to longer run time than the previous ones if the driving time is shorter than the long keypress repetition time
- Wrong handling in the update module if channels are not active
- In a switching group, only the first channels are switched on
- After a long button press, one channel will sporadically remain permanently supplied with 230 volts.
- No status frame if a level change (not 0) is done and the start level is != 0
** New Feature
- Implement channel parameter for setting the Dimm-Min-Level.
- Implement channel parameter for setting the Dimm-Min-Level.
- Switch-off ramp via central programs or automation.
** Improvement
- The time information telegram does not contain a note about the sommer / winter time change.
- Error on the display and in the status frame if mains power is missing, although the channel state is inactive
Version 1.0.0 - 2019-03-01
** Bugfix
- Weekprogram configuration lists are not working properly
- Event counter timeout isn't reset if within the triggered profile the multiexecution flag isn't set
- Short key press of key visual leads to a restart, if a factory reset was aborted before
- Answer-Frames are sometimes sent to the wrong IP destination
- Weekprogram doesn't work correctly if several virtual channels shall be triggered by one switching point
- Homematic IP actuators trigger, due to the astro function, one hour delayed or prematurely on the day of the time changeover.
- Divide maximum number of partners for virtual channels into individual values for virtual A, B and C
** Improvement
- Modify event counter check to meet current specification
- All PowerUp parameters, that are listed in list 3 of the device, must be supported.
- Add new parameter for Contrast
--- END OF FILE ---