sha256: 2c7468238b42c5f3f90da455da1154c205be62f58c59c2f6ba733f59fce33536
C H A N G E L O G
Please note: Only use the firmware file in connection with the current software-version of the CCUx!
Device: HmIPW-DRS4 - Homematic IP Wired Switch Actuator - 4 channels
Company: eQ-3, Maiburger Str. 29, 26789 Leer, Germany
Version 1.2.4 - 2018-08-27
** Bugfix
- If more than one status ACK frame is within the answer queue only the first one is send. Afterwards every new status ACK only triggers the last one
- Statusinfo module creates status ACK telegrams with set ACK, ARR and Boot bits if this is the first status to be sent after startup
- HmIP_APP: Send node confusion when using external send nodes
- Sometimes Statusinfo uses old ApplicationSequenceNumber and Statusinfo with ACK get lost
- Answer-Frames are sometimes sent to the wrong IP destination
- Weekprogram doesn't work correctly if several virtual channels shall be triggered by one switching point
Version 1.2.2 - 2018-07-05
** Bugfix
- Profile: Buffer for learned links can overflow
Version 1.2.0 - 2018-07-03
** Bugfix
- If the link partner is known, an NAK is sent on ("invalid") frames without ARR bit
- If "Disable Message to AC" is activated and only one channel is addressed, no App-Ack is sent.
- Direct Execution Commands without ARR bit are answered at application level
- Homematic IP actuators trigger, due to the astro function, one hour delayed or prematurely on the day of the time changeover.
- Divide maximum number of partners for virtual channels into individual values for virtual A, B and C
- Fix CCM flags according to RFC3610
** Improvement
- All PowerUp parameters, that are listed in list 3 of the device, must be supported.
- Add new parameter for Contrast
- Unify values for undervoltage
- Increase interval for switching actuator channels after power up
--- END OF FILE ---